Prusa i3 - Y axis slow response March 01, 2016 02:55PM |
Registered: 8 years ago Posts: 18 |
Re: Prusa i3 - Y axis slow response March 02, 2016 06:38PM |
Registered: 9 years ago Posts: 351 |
Re: Prusa i3 - Y axis slow response March 02, 2016 08:20PM |
Registered: 8 years ago Posts: 18 |
Quote
IMBoring25
When posting questions, please include at least machine type and firmware.
This behavior can occur when you have a normally-closed endstop that is not properly connected, so the machine thinks the endstop is always triggered. Some machines are configured to move to the endstop quickly, back off a little, and then hit the endstop again more slowly to get a more precise position. When this symptom is exhibited, only the backing-off movement occurs.
Re: Prusa i3 - Y axis slow response March 31, 2016 11:34PM |
Registered: 8 years ago Posts: 195 |
Re: Prusa i3 - Y axis slow response April 01, 2016 07:34AM |
Registered: 8 years ago Posts: 18 |