Nozzle diameter question March 04, 2016 07:50AM |
Registered: 8 years ago Posts: 32 |
Re: Nozzle diameter question March 04, 2016 09:42AM |
Registered: 8 years ago Posts: 318 |
Re: Nozzle diameter question March 04, 2016 12:22PM |
Admin Registered: 16 years ago Posts: 13,886 |
Re: Nozzle diameter question March 04, 2016 01:01PM |
Registered: 8 years ago Posts: 32 |
Quote
DaGameFace
Were these samples fromthe the bed? If so, that sounds about normal, it leaves the nozzle at.5 but them get squished and flattened by the edges of the nozzle. This is by design, it makes the fiLament stick to the bed other layers and we'll as neighboring extrusions much better
Re: Nozzle diameter question March 04, 2016 05:16PM |
Registered: 10 years ago Posts: 651 |
Re: Nozzle diameter question March 04, 2016 06:10PM |
Registered: 9 years ago Posts: 1,873 |
Re: Nozzle diameter question March 09, 2016 03:38AM |
Registered: 10 years ago Posts: 128 |
Re: Nozzle diameter question March 09, 2016 07:45AM |
Registered: 8 years ago Posts: 413 |
Re: Nozzle diameter question March 09, 2016 01:11PM |
Registered: 8 years ago Posts: 32 |
Quote
chngyian
From my experience, the extrusion in free air is pretty close to the nozzle size.I was getting 0.4-0.5 from a 0.4 nozzle.
Are you trying to find out the nozzle size or is it part of a bigger problem? You can consider getting one of those nozzle cleaning sets of aliexpress/ebay. Just go thru the sizes and you can find out the nozzle size.