Has anyone been able to get the auto bed leveling running reliably on an Azteeg X3??
Using a PNP/NO proximity sensor with 12v supply which is then leveled down through the resistor set... and into the middle signal port for the Azteeg board.
I'm using Marlin RC4 now with relative settings as:
[
// #define ENDSTOPPULLUP_YMIN
....
const bool Z_MIN_ENDSTOP_INVERTING = true; // set to true to invert the logic of the endstop.
]
M119 returns open with the sensor is inactive... yet it returns open when active.
