My Kossel 2020 was running fine with Repetier V91, but I have reinstalled everything on a new PC, and switched the firmware calibration to V92. Now when I give the Home command, the head is over-driving the End Stops.
Unfortunately, I have lost the original files and am starting over from scratch.
I am a newbie. Can anyone tell me where to look for the problem?
Folgertech Kossel Delta 2020 REV A
Arduino 1.6.11
Arduino Mega 2560
Repetier Host V1.6.2
Firmware: Repetier V0.92.9
Edited 1 time(s). Last edit at 09/29/2016 09:15AM by 3D-IsMe.