Newbie - advice on print please

Herri

Newbie - advice on print please
May 28, 2017 04:10AM

Registered: 7 years ago
Posts: 6

Can anyone suggest why these prints are not quite ok. Its PLA at 195 degrees
The bottom starts ok and towards the top it goes strange at the corners.
Thanks
David

Reply Quote

Attachments:
open | download - Test1.JPG (122.4 KB)
open | download - Test2.JPG (121.2 KB)

Floyd

Re: Newbie - advice on print please
May 28, 2017 02:26PM

Registered: 11 years ago
Posts: 770

Bet you dont have a print cooling fan.
It makes a world of difference with PLA

Reply Quote

o_lampe

Re: Newbie - advice on print please
May 29, 2017 02:05AM

Registered: 9 years ago
Posts: 5,232

You can use the "minimum layer time" setting in your slicer to slow down the print where needed, but the print fan will cool much better.

Reply Quote

drmaestro

Re: Newbie - advice on print please
May 29, 2017 02:26PM

Registered: 10 years ago
Posts: 330

Or you can print 2 copies of the same object, if it is a small one. This way, the object will have enough time to cool down. Of course, a fan would be a better solution.