G29 in start code doesn't seem to activate Mesh Bed Leveling January 02, 2018 05:26AM |
Registered: 8 years ago Posts: 46 |
//#define AUTO_BED_LEVELING_3POINT //#define AUTO_BED_LEVELING_LINEAR //#define AUTO_BED_LEVELING_BILINEAR //#define AUTO_BED_LEVELING_UBL #define MESH_BED_LEVELING
#define PROBE_MANUALLY
M107 ;start with the fan off G28 X0 Y0;move X/Y to min endstops G28 Z0; Move Z to min endstop G29 ;Enable Mesh Bed Leveling G92 E0 ;zero the extruded length G1 Z15.0 F9000 ;move the platform down 15mm
;FLAVOR:Marlin ;TIME:41268 ;Filament used: 63.7258m ;Layer height: 0.2 ;Generated with Cura_SteamEngine 3.0.4 M190 S60 M104 S210 M109 S210 M82 ; absolute extrusion mode M107 ;start with the fan off G28 X0 Y0;move X/Y to min endstops G28 Z0; Move Z to min endstop G29 ;Enable Mesh Bed Leveling G92 E0 ;zero the extruded length G1 Z15.0 F9000 ;move the platform down 15mm ;LAYER_COUNT:295 ;LAYER:0 M107 G0 F2400 X90.597 Y129.179 Z0.2 ;TYPEKIRT G1 F1800 X91.343 Y128.702 E0.02945 G1 X92.129 Y128.295 E0.05889 G1 X92.949 Y127.961 E0.08834 G1 X93.795 Y127.702 E0.11777 G1 X94.662 Y127.52 E0.14723 G1 X95.541 Y127.417 E0.17667 G1 X96.229 Y127.392 E0.19956 G1 X144.411 Y127.341 E1.80211 G1 X149.507 Y127.052 E1.97187 G1 X154.566 Y126.478 E2.14121.... And so on...
Re: G29 in start code doesn't seem to activate Mesh Bed Leveling January 02, 2018 05:49AM |
Registered: 8 years ago Posts: 46 |
Re: G29 in start code doesn't seem to activate Mesh Bed Leveling January 02, 2018 09:42AM |
Registered: 6 years ago Posts: 1,863 |