probleme axe

Salut,
Am facut o imprimanta de 300x300 prusa i3, am reusit sa printez cu mici decalaje si dintr-o data cand am dat home inainte sa faca axa x se aude un harait, se blocheaza pt cateva secunde ( in functie de viteza, daca e viteza mica se blocheaza mai mult, daca e mai mare mai putin), dupa care isi revine. Printez piese mici la viteza de 70-80% dar cand piesa este mai mare sau viteza mai mare la un moment dat haraie si se decaleaza. Aveti idee din ce cauza e deranjamentul?
Multumesc

Keine Ahnung was das bedeutet!

---

Laser: 50w Co2 SH-G350
Drucker: bq Prusa i3 Hephestos - Print Bed Expansion Kit - Igus RJZM-02-08 - TMC2100 - Alu-DDP + Silikonheizmatte 300w (300 x 200mm) - Netzteil Dell DA-2

... yes, it's a bit hard to translate - even the best AI-based transscripts are hard to read

"German":

Quote

Seid gegrüßt,
Wenn Sie den 300x300-Preis i3 drucken, können Sie die Daten wiederverwenden und zu Hause speichern, wenn blocheaza pt cateva secunde (in functie de viteza, daca e viteza mica se blocheaza mai mult, daca e mai mare mai putin), dupa care isi revine. Printez piese mici la viteza de 70-80% dar cand piesa este mai mare sau viteza mai mare la un moment dat haraie si se decaleaza. Haben Sie Vorstellungen von Vorsicht und Deranjamentul? Multumesc

"English":

Quote

Greetings,
Am facut o imprimanta de 300x300 prusa i3, am reusit sa printez cu mici decalaje si dintr-o data cand am dat home inainte sa faca axa x se aude un harait, if blocheaza pt cateva secunde (in functie de viteza, daca e viteza mica se blocheaza mai mult, daca e mai mare mai putin), dupa care isi revine. Printez piese mici la viteza de 70-80% dar cand piesa este mai mare sau viteza mai mare la un moment dat haraie si se decaleaza. Do you have ideas about caution and deranjamentul?
Multumesc

---

Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]

) sorry,

I made a 300x300 p3 i3 printer, I managed to print with small gaps and once I got home before making the x axis a nose, it hangs for a few seconds (depending on the speed, if the speed is low is blocked longer, if it is less), then returns. I print small pieces at the speed of 70-80% but when the piece is bigger or the speed its faster at a certain moment it shakes and deforms. Do you have any idea of the cause?

escuse my english, thank you