Error: Printer halted. kill() called! on homing (Marlin 1.1.9)

Help!

Building my first printer, and every time I try to home any axis (or start a print job for that matter), I get this error when the axis arrives at it's home position. I have no mechanical endstop, using a MKS GEN1.4 board.

Attached here is my config and my printer settings in Repetier Host. If anyone is able to help I'll be eternally grateful!

Edited 1 time(s). Last edit at 09/20/2018 03:28PM by Arakahn.

Please take an picture of the error, there should be a reason listed as to why kill was called.

Sadly there isn't, which is why I'm so exasperated (see attached)

In MatterHackers I got this in the log though, don't know if it helps

<-Error: Printer halted. kill() called!
->N311 M114*36

Edited 1 time(s). Last edit at 09/21/2018 11:02AM by Arakahn.

try an experiment

just send a "G28 Y0" to the printer from the control program
Does this also crash?
Does it home Y first?

Secondly just trigger the Y endstop by hand, does this also crash the machine?

also take a read of [reprap.org] someone else having what looks to be the same issue

Edited 1 time(s). Last edit at 09/22/2018 01:16AM by Dust.

Check if the end stops aren't accidentally connected to short out +5V and GND. That would cause a brown out interrupt. I don't know how Marlin handles it, it could just be that it doesn't report a brown out and just halts the printer.

---

--
Kind regards
Imqqmi

NFAN CoreXY printer:
[reprap.org]