this is my g-code on a print that just finished:
SENT: G1 X124.987 Y125.751 F1920
SENT: G92 E0
READ: ok
SENT: G1 E-3.6000 F4800
SENT: M104 S0
READ: ok
SENT: M140 S0
READ: X:124.99 Y:125.75 Z:90.98 E:0.00 Count X:12537 Y:12989 Z:36399
READ: ok
SENT: G1 Z5 F5000 X0 F5000
SENT: M84
Total build time: 501.31 minutes
READ: ok
i'm not sure what happened but as soon as the print finished, the bed started going up and the model crashed into the hot end. I was able to remove the model before it was too damaged and noticed the bed was going to continue into the hot end and the hot end carriage itself was slowly edging toward the edge of the bed as well. I shut down the printer before anything crashed but I am hoping someone here would be able to tell what is happening. I have an FLSUN Cube running Marlin bug fix 1.1.9