I have an Anet A8 that has been a fantastic performer. And then I put a roll of eSun White PLA+ on it. Now it looks like this.
Total crap. Actually, to even get this good I had to increase flow to 110%.
I am about to embark upon a quest to look at filament diameter, desiccant bake, temperature hunting, extrusion rate, retract rate and distance, and...?
If anyone has seen this before I'd love to know what you found and did.
Many thanks,
DLC
Kits: Folgertech Kossel 2020 upgraded E3Dv6, Anet A8 upgraded E3Dv6, Tevo Tarantula enhanced parts and dual-head, TronXY X5SA Pro(E3DHemera).
Scratch: Large bed Cartesian, exchangeable heads, Linear slide Delta, Maker-Beam XL Micro Delta, 220x220CoreXY.