Hello reprapers !
I have a quick question before turning crazy.
Did you ever experience your printer to raise Z axis all the way up on the Xhoming process ?
Here is my config :
- ramps
- XY : TMC2130 with sensorless homing
- Z : A4988
- Marlin 1.1.9
I have removed my Zprobe and changed it for an endstop (Undefined Zprobe in firmware as well)
When i start a G28 X : the Z axis will raise approximately 100mm before eventually homing.
This is really strange behavior.
Thank you community for letting me know whether i alone or not with this issue
Cheers
Thomas