Dragon with Peek filament

Hi all.

The most expensive dragon I ever print. It's only 80mm height. cost: $32

Peek: 1.75mm

layer height: 150 micron
speed: 20mm/s
infilled: 40%
nozzle: 0.4
heat: 395C
Bed: 140C
chamber: 70C


p.s. Have you guys try dragon before, what is the lowest layer height 200micron or 100micron or 50micron...etc....

It came out great! Are you using a water cooled hot end? What kind of printer? Are you going to anneal it?

Edited 1 time(s). Last edit at 03/11/2019 06:28AM by Shank man.