Welcome! Log In Create A New Profile

printing

Posted by furko225

Forum List Message List New Topic

furko225

printing
April 11, 2019 12:54PM

Registered: 5 years ago
Posts: 7

Hi everyone, when I'm going to print the extruder x and y axis is going to infinity what is the solution to it?

Reply Quote

Roberts_Clif

Re: printing
April 11, 2019 02:11PM

Registered: 6 years ago
Posts: 1,863

Quote
furko225
Hi everyone, when I'm going to print the extruder x and y axis is going to infinity what is the solution to it?

Quote
furko225
I downloaded and installed Repetier to set the calibration of my Prusa i3. Display model LCD 2004

A couple question first.

Did you Install the Firmware in your Prusa i3 3D Printer? If so what firmware did you install?
What Slicer are you using.

If you setup and installed your Prusa i3 3D Printers firmware then post configuration.h file Please.

Computer Programmer / Electronics Technician

Reply Quote

imqqmi

Re: printing
April 16, 2019 03:54AM

Registered: 9 years ago
Posts: 752

Your 3D printer must be very large. Maybe the big bang didn't happen, the entire universe is all 3D printed with your printer winking smiley