Welcome! Log In Create A New Profile

Advanced

printing

Posted by furko225 
printing
April 11, 2019 12:54PM
Hi everyone, when I'm going to print the extruder x and y axis is going to infinity what is the solution to it?
Re: printing
April 11, 2019 02:11PM
Quote
furko225
Hi everyone, when I'm going to print the extruder x and y axis is going to infinity what is the solution to it?

Quote
furko225
I downloaded and installed Repetier to set the calibration of my Prusa i3. Display model LCD 2004
A couple question first.

Did you Install the Firmware in your Prusa i3 3D Printer? If so what firmware did you install?
What Slicer are you using.

If you setup and installed your Prusa i3 3D Printers firmware then post configuration.h file Please.


Electronics Technician / Computer Programmer
Re: printing
April 16, 2019 03:54AM
Your 3D printer must be very large. Maybe the big bang didn't happen, the entire universe is all 3D printed with your printer winking smiley

I'll see myself out.


--
Kind regards
Imqqmi

NFAN CoreXY printer:
[reprap.org]
Sorry, only registered users may post in this forum.

Click here to login