All,
I try to set up Marlin 1.1.9 (with bug fixes 1.1) but the auto bed leveling (3 point) is not working properly: The Hall sensor misses the bed and thus I must
change the coordinates of the 3 probe positions. The problem is that when I change these coordinates the probing points stay the same.
My starting script looks like this
G1 Z 10 F5000
G28
M420 S1
G29
to make sure that auto bed leveling is on.
My hall sensor is situated left to the nozzle (See attached photo)
My Configuration.h is attached. I do hope that someone can help!
Thanks in advance!
JWD
