A most epic print fail

Someone was running the Prusa I3 at the makerspace a few days ago and started a print using the wrong printer profile. The result was absolutely incredible!







While it might be possible to clean off the heater block and free up the thermistor leads with a few hours of work and a heat gun, I think I'm just going to order new parts. We'll also have to print a new fan bracket or two.

---

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]

Holy potpie Batman! My worst FUBAR did not go that bad!

Wow.

DLC

---

Kits: Folgertech Kossel 2020 upgraded E3Dv6, Tevo Tarantula enhanced parts and dual-head, TronXY X5SA Pro(E3DHemera).
Scratch: Maker-Beam XL Micro Delta, 220x220CoreXY.
Actually bought: Bambu Labs X1 Carbon

I have learned to always expect the unexpected at the makerspace!

No, that wasn't that new marshmallow filament you've heard so much about. It was plain ol' ABS.

Edited 1 time(s). Last edit at 11/27/2019 12:18PM by the_digital_dentist.

---

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]

That must have taken hours... whom ever was meant to be watching the printer needs the "Cat o' nine tails"

holy crap!

yes the "Cat o' nine tails" is strongly recommended for not watching the printer for even just a few minutes.