Hi, I have some problems with my new board, a Fysetc F6 V1.3, that I want to solve:
A few weeks ago, I bought this new board, to upgrade my printer, so that I could print with various colors. This new setup includes:
- The new board, Fysetc F6 V1.3
- A power supply of 12V and 30A (380W)
- A HotEnd with a 40W resistor and a thermistor type 3950
- Microsteppers A4988
- Nema 17 motors (2 motors per axis)
- A ReprapDiscount Full Graphic Smart Controller screen
- TL-W5MC1 limit switches (1 per axis)
- Firmware: Marlin 1.1.9 (downloaded from the Fysetc website)
My previous setup included:
- A Ramps 1.4 board with Arduino atmega 2560
- A 12V, 10A (120W) power supply
- Firmware: Marlin 1.1.x
The problems I have are:
1 - When I tell it to do the homing, it stays a while thinking and then it gives me an error: Printer halted. kill() called! Although I have managed to get it to print something sometimes, after that, without having touched anything on the printer, it doesn't move. The only thing I can do is to heat the extruder, always receiving a correct temperature.
2- I've managed to get the screen to work, but the pixels don't come out as they should and when I turn the selector, the printer restarts.
PS: Sorry for my bad English
