Welcome! Log In Create A New Profile

shifting every layer

Posted by didriksson69

Forum List Message List New Topic

didriksson69

shifting every layer
January 08, 2020 09:49AM

Registered: 4 years ago
Posts: 5

Y axis move about 2mm in wave shape and x axis 0,5mm. Help please!

Reply Quote

didriksson69

Re: shifting every layer
January 08, 2020 09:54AM

Registered: 4 years ago
Posts: 5

pic

Reply Quote

Attachments:
open | download - 20200108_152641 (2).jpg (890.4 KB)

the_digital_dentist

Re: shifting every layer
January 08, 2020 09:57AM

Registered: 11 years ago
Posts: 5,780

Post a few pictures of the printer.

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]

Reply Quote

didriksson69

Re: shifting every layer
January 08, 2020 10:29AM

Registered: 4 years ago
Posts: 5

printer

Reply Quote

Attachments:
open | download - 20200108_161905 (2).jpg (731 KB)

didriksson69

Re: shifting every layer
January 08, 2020 10:38AM

Registered: 4 years ago
Posts: 5

Mainboard

Reply Quote

Attachments:
open | download - 20200108_163207.jpg (236 KB)

the_digital_dentist

Re: shifting every layer
January 08, 2020 12:15PM

Registered: 11 years ago
Posts: 5,780

Jog the Z axis up and down and watch the X axis- does it wobble back and forth?
Move the Y axis back and forth- does it wobble?
Grab the heater block on the extruder (while it's cold!) and try wiggling it.

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]

Reply Quote

didriksson69

Re: shifting every layer
January 08, 2020 01:46PM

Registered: 4 years ago
Posts: 5

The y shaft-screw was not proper installed so that came close to perfect for the Money 100€. The bearings was to tight for belt on x axis but now 1mm wave. Any suggestion?