Extruder stops temporarily during print March 25, 2020 01:08PM |
Registered: 11 years ago Posts: 13 |
HyperCube Evo 300^3 adapted for 2020 extrusion and 10mm smooth rods XYZ steppers: 17HM0423 / 0.9º / 2.3A / 4200g.cm E Stepper: 42BYGH47-401A / 1.8º / 1.68A / 5400g.cm Bed Leveling: BLTouch clone and Linear leveling Hotend: Volcano clone with 0.4 noozle Extruder: Titan Extruder Heated bed, all electronics powered @24V Electronics: SKR 1.3 with: XY: TMC2209 @1.5A / Z1,Z2: TMC2130 @1.2A / E: TMC2208 @1.25A Firmware: Marlin bugfix-2.0.x from 2019-11-22 Octopi on RPI3B, filament runout sensor Slicer: Cura 4.5
Re: Extruder stops temporarily during print March 25, 2020 06:37PM |
Registered: 11 years ago Posts: 5,780 |
Re: Extruder stops temporarily during print March 27, 2020 08:10PM |
Registered: 11 years ago Posts: 13 |
Re: Extruder stops temporarily during print March 28, 2020 08:54AM |
Registered: 6 years ago Posts: 1,863 |
Re: Extruder stops temporarily during print March 28, 2020 09:42AM |
Registered: 11 years ago Posts: 5,780 |