Sequential Printing April 03, 2020 12:30PM |
Registered: 6 years ago Posts: 1,863 |
Re: Sequential Printing April 20, 2020 08:15AM |
Registered: 5 years ago Posts: 20 |
Re: Sequential Printing April 20, 2020 09:18AM |
Registered: 6 years ago Posts: 1,863 |
Quote
tabana
You need to check gantry height in Cura machine settings. Part height must be lower than that value to succeed slicing. Not recommended, but you can enter higher number there, but have in mind that print order is important in that case.
Re: Sequential Printing April 20, 2020 09:40AM |
Registered: 8 years ago Posts: 413 |
Re: Sequential Printing April 20, 2020 02:36PM |
Registered: 6 years ago Posts: 1,863 |
Quote
MCcarman
If this box is based on the print head size it may be possible to reduce the size by only entering the biggest offset in X or Y.