Welcome! Log In Create A New Profile

YMIN

Posted by edensan

edensan

YMIN
June 14, 2020 05:18AM

Registered: 3 years ago
Posts: 23

I have a *lcd2004
MKS-gen-L-v1.0
3D touch
Fillament runout sensor*

I run the marlin firmware 2.0.5.x on a *RepRap Discount Smart Controller* and *MKS_GEN_L motherboard*.

Everything works fine but for the mechanical y-min switch: it stays triggered.

(m119) YMIN work under 1.1.2 ao everything is connect right and is physicly working.

I don't know what to do... Does maybe someone have an idea of what I can do?

2Vav0.jpg

Flsun

These are my files:

pins_RAMS.h
configuration.h
configuration_adv.h

Edited 4 time(s). Last edit at 06/14/2020 02:42PM by edensan.

Reply Quote

ruggb

Re: YMIN
June 14, 2020 07:33AM

Registered: 9 years ago
Posts: 294

there are a few posts about this. Maybe something is wrong with the pins file. Try using Y-Max pin. Others have done that. with success.

Reply Quote

edensan

Re: YMIN
June 14, 2020 07:44AM

Registered: 3 years ago
Posts: 23

Im not that experianced can and wil you explaine how i do this?

Thx in advance

Edited 1 time(s). Last edit at 06/14/2020 08:15AM by edensan.

Reply Quote

edensan

Re: YMIN
June 14, 2020 11:46AM

Registered: 3 years ago
Posts: 23

i changed pins 14 to 15 and 15 to 14 no difference thx to PomAdam in this tread

Edited 1 time(s). Last edit at 06/14/2020 11:57AM by edensan.

Reply Quote

edensan

Re: YMIN
June 14, 2020 03:58PM

Registered: 3 years ago
Posts: 23

i did put back a (working} backup and also no endstop and inverted y! confused smiley

HELP!!!!!

Reply Quote

ruggb

Re: YMIN
June 14, 2020 04:07PM

Registered: 9 years ago
Posts: 294

move your endstop connector to YMAX port and change the config to use Ymax for the Y endstop.
I have not done this. Just reading from posts on Marlin Git Issues

[github.com]
[github.com]

check them out

Reply Quote

edensan

Re: YMIN
June 14, 2020 05:03PM

Registered: 3 years ago
Posts: 23

verry strange i put the plug in the ymax and its working!!

Reply Quote

ruggb

Re: YMIN
June 14, 2020 06:30PM

Registered: 9 years ago
Posts: 294

Yeah, sounds like something is wrong with the pins file.
You can probably fix it if you wanted but Marlin should do it.

Reply Quote

MCcarman

Re: YMIN
June 15, 2020 06:15AM

Registered: 8 years ago
Posts: 413

Bye the way.
Don't run the Bowden as shown in the picture. Don't tie wrap to the cable near the hot end - it creates a horrible bend in the tube and doesn't feed smoothly into the hot end.
Not sure how they managed to get the cable deflected that much - i assume they clamped the cable just for the photo but it wont work when you try to level the bed.