What am I looking at here? (Top layer bumpy lines) July 17, 2020 06:06PM |
Registered: 9 years ago Posts: 157 |
Re: What am I looking at here? (Top layer bumpy lines) July 18, 2020 03:55AM |
Admin Registered: 11 years ago Posts: 3,096 |
Re: What am I looking at here? (Top layer bumpy lines) July 18, 2020 03:57AM |
Registered: 9 years ago Posts: 157 |
Re: What am I looking at here? (Top layer bumpy lines) July 18, 2020 04:43AM |
Admin Registered: 11 years ago Posts: 3,096 |
Quote
Arakon
4 top layers, infill is 100%.
Thing is, it used to print near perfect top surfaces on the other print bed. The bottom was horrible, though, half torn up, wildy varying adhesion, etc.
I seem to have thicker lines in between the flat ones, so I'm rather guessing it may be overextrusion, not under? I reduced the flow by 2% now and am testing again.
Re: What am I looking at here? (Top layer bumpy lines) July 20, 2020 11:19AM |
Registered: 8 years ago Posts: 413 |