Hello All, was hoping for some troubleshooting help. I recently installed underbed piezo sensors and a precisionpiezo PCB on my CR10S. I've managed to physically connect everything, I have the piezo connected to the Z min stop pins on the board (it's a v2.0 board). I also have the printer connected to a rpi running octoprint. I have been able to get the sensor to auto home correctly, but as soon as I attempt to execute a G29 command, I run into a problem. The nozzle will successfully measure the first position of the grid, but then move to the second position and stop, giving me an M112 code. I was hoping someone could tell me what is causing this. I have attached my Configuration.H File as well as the Terminal Log from Octoprint.
