Welcome! Log In Create A New Profile


Inductive sensor causing embossed print

Posted by lowfat 
Inductive sensor causing embossed print
April 08, 2021 04:44PM
The inductive sensor on my printer is causing an embossed logo to show up on prints. The logo is a perfect copy of the bottom side of the inductive sensor. Sensor is a PL-08N @ 24V using a voltage divider. The bed is an aluminum PCB heater. Printer is running Klipper if that matters. What could cause this and is there anyway to resolve it?

This one was a finished print, which was about 7mm height.

And then I noticed this later in the day.

From the backside

Sorry, only registered users may post in this forum.

Click here to login