Remove unattached lines in slicer
July 26, 2021 08:21AM
Planning on printing the Thingiverse T Rex skeleton.
When I slicer a lot of the parts there are a number of unattached lines around the thin features that will just make a total mess of the part. Take a look at the attached image.

Is there a way to remove these?

I'm using Prusa slicer at the moment.
Attachments:
open | download - 2021-07-26 13_16_54-Window.png (143.1 KB)
Re: Remove unattached lines in slicer
July 26, 2021 04:34PM
Are those unattached lines the bottom of support structures? If so then you could possibly change the support settings to have them all connect. You might need help from a Prusa Slicer expert...
Sorry, only registered users may post in this forum.

Click here to login