Welcome! Log In Create A New Profile

Advanced

not sure what is causing this

Posted by Nikki81 
not sure what is causing this
July 29, 2022 05:57AM
I am just tuning my ratrig build and it decided to try a vase mode print. The extruder steps are set perfectly and there is good layer cooling the rest of the print is fabulous its just the top shoulders and chest that there is a problem. I am using simplify3d 4.1



Thanks Nikki

Edited 2 time(s). Last edit at 07/29/2022 06:18AM by Nikki81.
VDX
Re: not sure what is causing this
July 29, 2022 06:25AM
... no or not enough support and to hot/soft, so its' sagging ...


Viktor
--------
Aufruf zum Projekt "Müll-freie Meere" - [reprap.org] -- Deutsche Facebook-Gruppe - [www.facebook.com]

Call for the project "garbage-free seas" - [reprap.org]
Re: not sure what is causing this
July 29, 2022 10:43AM
I found the fix. I reduced my layer Hight to 0.1000 after closely looking at the preview after slicing i could see that there were gaps.
Sorry, only registered users may post in this forum.

Click here to login