Feature request: different layer with/(and height?) for infill ?

Hy guy`s

I`m printing with a 0,3mm nozzle and noticed that i can also print 0,5mm width with it without problems (for example at 0,2mm layer height)

my thought was to change the the width of the infill for speeding up the printing process ?

or even make a feature like Skeinforge`s "Skin" to do two layer perimeter on the outside but only one big Layer of Infill on layers that don`t change.

This should speed up the printing process of large objects a lot ?

mfg Chri

There is already a setting "Infill Every N Layers" which does this. If you set your layer height to 0.2mm and set this value to "2", it will infill using 0.4mm layers.

Oh okay, i thought the "infill every N Layers" make a normal full infill every "N" Layer , so i never tried its

thx

mfg Chri