Slic3r 0.8.5dev new flow branch support material problem
July 09, 2012 05:15PM
Trying to print this week's competition part using the new flow branch. It's not putting in all the required support material in the first couple of layers so ends up trying to print on free air. Take a look at here for the stl file.

Is anyone else aware of support material problems? Should I raise an issue in github? I can't see that any changes that are labeled as fixes to support since 0.8.4 was delivered that might not be in 0.8.5dev New flow


Using ABSPrusa Mendel Zaphod with Pronterface and slic3r 1.3.0. Printing well with 3mm PLA and ABS through 2 x J Head Mk IV b and Wade Geared Exruders. Controlled using RAMPS1.4 board running Marlin_v1.1.9
Sorry, only registered users may post in this forum.

Click here to login