Welcome! Log In Create A New Profile

Advanced

What happened to the newflow branch?thumbs down

Posted by MotoBarsteward 
Forum List Message List New Topic
MotoBarsteward
What happened to the newflow branch?thumbs down
July 15, 2012 10:10AM
I just looked and there it was, gone!

This branch seemed to work very well with my J Head.

Using ABSPrusa Mendel Zaphod with Pronterface and slic3r 1.3.0. Printing well with 3mm PLA and ABS through 2 x J Head Mk IV b and Wade Geared Exruders. Controlled using RAMPS1.4 board running Marlin_v1.1.9
Reply Quote
pokey9000
Re: What happened to the newflow branch?thumbs down
July 15, 2012 12:06PM
It was merged into master yesterday!
Reply Quote
MotoBarsteward
Re: What happened to the newflow branch?thumbs down
July 15, 2012 01:38PM
That's the problem with having two eyes and ten fingers...

I tend to use them in that proportion!

Just brought down the latest code from the master and trying it.

Using ABSPrusa Mendel Zaphod with Pronterface and slic3r 1.3.0. Printing well with 3mm PLA and ABS through 2 x J Head Mk IV b and Wade Geared Exruders. Controlled using RAMPS1.4 board running Marlin_v1.1.9
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login