Hello,
I'm using PETG. I don't want the print fans to be on unless certain criteria are met, so I use the auto on feature. With that setting enabled, I have the fan set to 100% when bridging occurs. However, I printed one of those bridge test stl's, and the fan does not come on. The only way to get the fan on is with the always on setting. How do I get slic3r to kick in the fans during a bridge with the auto on feature? Is there no way to do this without the always on setting?
Edited 1 time(s). Last edit at 03/26/2016 02:59PM by mlaustin66.
