Using PLA and Slic3r, I have a slight issue with puckering on the top layer (see image). I say slight issue because for the most part it has not caused me any functional problems, only visual ones. I can get rid of most of it with a file.
Question is, how should I go about getting rid of this. In slic3r, I have played around with the extrusion multiplier and that doesn't seem to fix the issue and sometimes causes other issues. (clearly I don't know what I am doing with it).
Is there a good way to address an issue like this?
Attachments:
open |
download -
20190104_093637.jpg
(607.2 KB)