Hi everyone,
Im really new to this and I have got a question on how I could alter 'hatching spacing'.
For example:
Shown in the attached screenshot, I am trying to print that inner cylinder with a different hatch spacing to the outer cylinder.
I was told I can adjust layer height but if I do it on slic3r does it only affect the top surface of the inner cylinder and not the entire inner cylinder?
Im not really sure how to go about this.
Thanks for the help in advance
Attachments:
open |
download -
Screen Shot 2019-03-29 at 14.09.15.png
(91.7 KB)