g-code leads to: Print doesn´t stop when printhead is traveling

Hey everyone,

I am new to 3D-printing and worked with slic3r to create a simple cylinder with a grid structure. The problem I am having now is that when the g-code is generated somehow the instructions for turning off printing when travelling to a new location are missing. I created a commented g-code (both attached, settings for the print may vary), in which you can see where the extruder retracts, so I could manually input the commands but that is too inconvenient.
Can somebody help?

I think most slicers have options for retraction. I know Slic3r and Prusaslicer have it. If using that look under Printer Settings/Extruder

Thank you for your answer.
I searched in the print & printer settings and found options for retraction but nothing about turning the print on/off.
So the print still doesn´t stop when the printhead is retracting.
(And yes, I am using Slic3r)

Edited 1 time(s). Last edit at 07/13/2021 08:12AM by Klara.