Welcome! Log In Create A New Profile

Slic3r 0.9.7 adds infill not wanted...

Posted by skarab

skarab

Slic3r 0.9.7 adds infill not wanted...
December 16, 2012 06:09AM

Registered: 11 years ago
Posts: 242

Hello,

First of all sorry for my bad English.

Quicky Slic3r 0.9.7 adds unwanted filling.
I'm not sure it be a bug, but with version 0.9.3 I have no problem with this part (x-carriage.stl).

Better than words, pictures, stl/gcode & config files smiling smiley

https://www.dropbox.com/sh/ealk618j6h3b65t/7aRj1NCYzs

Thank you for your help.

Peace.

_{"Ils ne savaient pas que c'était impossible alors ils l'ont fait!" Mark Twain

[DOC][CONFIG] Hauteur de couche (Layer height)

Lautr3k - A 3D printer without belts

iTopie - A Swissmade RepRap}

Reply Quote

Phizinza

Re: Slic3r 0.9.7 adds infill not wanted...
December 16, 2012 06:39PM

Registered: 12 years ago
Posts: 160

You're not the only one that has experienced this. I had it on a model I printed yesterday. In the STL the box was hollow, printed and randomly inside the box it would bridge across. On the 50mm high box it did probably 15 layers of fill. It ended up looking pretty messy but I just cleaned it up with a knife.

Reply Quote

tmorris9

Re: Slic3r 0.9.7 adds infill not wanted...
December 17, 2012 02:41AM

Registered: 11 years ago
Posts: 1,171

Yea, it's a known bug. I ran into this today. It's already been submitted to support. For now on holed items I am reverting back to 0.7.2b

Too bad as the surface of items in 0.9.7 are a bit smoother.