The automatic extra perimeters does not seem to be working in 0.9.7. Printing items with a domed top surface it is very obvious when the slope drops below 30 (?) degrees and adjacent perimeters start to separate from each other.
Box "Generate extra perimeters when needed:" is ticked in the config page.
I'm printing 0.3mm layer thickness at a 0.5mm layer width if that is relevant.
Can someone confirm if it is just me, or is there a bug ?
Thanks, Andrew
Edited 2 time(s). Last edit at 12/17/2012 10:11AM by AndrewC.