Hi,
Using the latest 0.9.8 build.
I currently have the following set under cooling :-
Enable Cooling: Ticked
Fan Speed Min: 40
Fan Speed Max: 100
Bridges Fan Speed: 100
Disable fan for the first: 1 Layers
Keep fan always on: Unticked
Enable fan if layer print time is below: 1 Seconds
Slow down if layer print time is below: 60 Seconds
Min Print Speed: 10 mm/s
I am printing with ABS and want the fan to run whilst printing bridges only. The fan does not operate until a bridge is printed but then stays on long after the bridge is finished...
Is this a bug or am I doing something wrong?
Regards
Andy Hodges
Edited 1 time(s). Last edit at 01/19/2013 09:29AM by AndyH.