Welcome! Log In Create A New Profile

Slicing issue

Posted by MPower

Forum List Message List New Topic

MPower

Slicing issue
February 07, 2013 02:17PM

Registered: 13 years ago
Posts: 195

What exactly is happening when you get wrong gcode from Slic3r, such as the images attached?

Reply Quote

Attachments:
open | download - perimeter-wt.stl (8.9 KB)
open | download - slic3r1.jpg (34.7 KB)
open | download - slic3r2.jpg (57.7 KB)

rhmorrison

Re: Slicing issue
February 08, 2013 02:45AM

Registered: 16 years ago
Posts: 3,742

In your case the STL file has errors.
This can be the cause for such slicing errors.
I corrected the problem using netfabb Studio Basic.

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse

Reply Quote

Attachments:
open | download - perimeter-wt (repaired).stl (5.9 KB)

MPower

Re: Slicing issue
February 08, 2013 02:58AM

Registered: 13 years ago
Posts: 195

Thanks. Could you please provide further details about the errors in that STL file? I am trying to understand what exactly was wrong with it, so I can correct the others too.

Reply Quote

rhmorrison

Re: Slicing issue
February 08, 2013 03:22AM

Registered: 16 years ago
Posts: 3,742

Click on the link that I provided in the last post to netfabb Studio Basic.
Download and install the program.
You can load an STL into the program and if it has problems.

See THIS POST for more detailed instructions.

Bob Morrison
Wörth am Rhein, Germany
"Luke, use the source!"
BLOG - PHOTOS - Thingiverse