Welcome! Log In Create A New Profile


Order of extrution

Posted by nikbjo 
Order of extrution
February 14, 2013 03:52PM
When printing an extruder gear i noticed that slic3r does a "bad" job of ordering where to extrude, when extruding the inside of the spurs it is done in decreasing y-order (down the y-axis) which makes alot of extra moves compared to if it was extruding the closesed unextruded part.
open | download - slic3r_gear.png (515.3 KB)
Sorry, only registered users may post in this forum.

Click here to login