Welcome! Log In Create A New Profile

0.9.9 bridging not as good as 0.9.8

Posted by Phizinza

Phizinza

0.9.9 bridging not as good as 0.9.8
April 13, 2013 03:03AM

Registered: 12 years ago
Posts: 160

Check out these two sets of gcode. The older version draws straight lines across the "grip pads" to bridge while the newer version of Slic3r goes diagonally. Which leaves a result no where near as good on my Prusa.

I'll just slice this part with the old version for now but just thought I'd point it out.

Cheers,
Phiz

Reply Quote

Attachments:
open | download - tri-glide buckle [slic3r v0.9.8].gcode (314.3 KB)
open | download - tri-glide buckle [slic3r v0.9.9].gcode (308.1 KB)

GITRDUN

Re: 0.9.9 bridging not as good as 0.9.8
April 14, 2013 12:16AM

Registered: 12 years ago
Posts: 253

Im also having bridge issues with 9.9 .

Reply Quote

jbernardis

Re: 0.9.9 bridging not as good as 0.9.8
April 14, 2013 07:13PM

Registered: 11 years ago
Posts: 1,320

I'm having bridging issues with slic3r period. O.9.8 and 0.9.9. I have the flow modifier down to 0.5 and I still get sagging - even for relatively short bridges. In fact I'd go far enough to say that changing the parameter seems to have no affect of the printed output.

Edited 1 time(s). Last edit at 04/14/2013 07:13PM by jbernardis.

Reply Quote

GITRDUN

Re: 0.9.9 bridging not as good as 0.9.8
April 20, 2013 10:33PM

Registered: 12 years ago
Posts: 253

Using 9.8 i can adjust the parameter and get good results. I went down to .65 % to stop the sagging.

Reply Quote

stoof

Re: 0.9.9 bridging not as good as 0.9.8
April 21, 2013 07:45PM

Registered: 11 years ago
Posts: 38

Bridging is definitely not working in 9.9.

I attached a screenshot of a bridge section. The perimeters bridge across just fine but the infill does not.

9.9 has been great but this is very class ic slic3r, fix one thing break another.