Erratic Perimeter generation
Posted by N314
|
Erratic Perimeter generation April 23, 2013 09:22PM |
Registered: 12 years ago Posts: 188 |
So Ive sliced models and lately ive noticed the perimeters are just crap in some places, and its in the Gcode.
The corners are just randomly cut off.
Any ideas if its my config, or slicer itself.
Using 9.8
-Nick
The corners are just randomly cut off.
Any ideas if its my config, or slicer itself.
Using 9.8
-Nick
|
Re: Erratic Perimeter generation April 28, 2013 11:30AM |
Registered: 12 years ago Posts: 188 |
|
Re: Erratic Perimeter generation June 11, 2013 05:25PM |
Registered: 13 years ago Posts: 81 |
I've noticed this. I have a Bowden feed for my Huxley and although it seems to stop early on some corners. The residual tension in the tube causes a blob, I think this stops the feed just before the end of travel so that the blob simply fills in the gap and looks less blobby.
Not noticed any problems with the prints themselves.
Not noticed any problems with the prints themselves.
|
Re: Erratic Perimeter generation June 11, 2013 10:00PM |
Registered: 11 years ago Posts: 14 |
N314 Wrote:
-------------------------------------------------------
> This is still happening with all files.
>
> This problem is specific to corners.
>
>
> -Nick
Could be thousands of problems of course. Maybe one of them is it doesn't stick well enough at the heatbed?
Edited 1 time(s). Last edit at 06/11/2013 10:02PM by hardwareaddict.
-------------------------------------------------------
> This is still happening with all files.
>
> This problem is specific to corners.
>
>
> -Nick
Could be thousands of problems of course. Maybe one of them is it doesn't stick well enough at the heatbed?
Edited 1 time(s). Last edit at 06/11/2013 10:02PM by hardwareaddict.
Sorry, only registered users may post in this forum.