deactivate wait temperature

Hello,
I'd like to know if in slic3r can deactivate wait temperature (M116) automatically during the generation of Gcode.
sincerely,
Jonathan

Yes, go into "Filament settings", "Filament" and set all 4 temps to zero. (Set temps manually in Host s/w)

---

_______________________________________
Waitaki 3D Printer

Not sure if this is what you mean but I use these codes in my 'start Gcode' section so that prints start without waiting for extruder or bed temp to be exactly right:

M104 S190 ;set extruder temp to 190 C and don't wait
M140 S55 ;set bed temp to 55 C and don't wait

Thank you Waitaki for information.

Mine is more elaborate, but as for temperature my custom start Gcode has these:

M140 S[first_layer_bed_temperature] ; start heating bed
G28 X0 Y0; home X&Y
G1 X50 Y0 F6000
M109 S[first_layer_temperature] ; extruder temp wait
M190 S[first_layer_bed_temperature] ; bed temp wait

I do this so that the time waiting for temperature is waiting on the "long pole", the nozzle temp. By the time the nozzle is up to temp, the bed has long been stable (so the M190 command takes minimal time).

Other commands that follow the above finish auto-homing Z, and extruding an "anchor" blob just prior to printing. It makes for improved first-layer success, as in, it works 100% now.