Hello everybody,
i have a problems with my retraction settings in Kisslicer.
no matter what combination of suck /prime /wipe i use, there are never real good retractions settings for my 0.5 noozle.
with Slic3r i have really good, almost perfect retraction settings. (0.5 noozle, jhead, ABS, 1.1mm lenght, speed 65mm/s)
so i tryed to adapt same values to Kiss suck/prime 1.1, speed 65mm/s, wipe of - and its a mess.
i get stripes on every move and dots on every start and end of a layer.
on one abs material i had good kisslicer settings with 0.6 prime/suck and 8mm wipe at 85mm/s. The ABS Spool was done and i started a new spool and again stripes and dots everywhere
isnt there a nice way to read the retraction settings in the gcode from a slicer print and adapt it to Kiss ?
hope you can help me
best
Edited 1 time(s). Last edit at 03/11/2014 11:42AM by Repper.