Welcome! Log In Create A New Profile


What parameters activate "bridge" extrusion

Posted by Bill Clark 
What parameters activate "bridge" extrusion
April 27, 2014 04:58AM
I am using this function in infill to increase strength and reduce the potential for delamination. but need to make sure it isn't active in other areas . I will assume it is the spacing of the previous layer. If so what is that spacing or is it something else

Edited 1 time(s). Last edit at 04/27/2014 04:59AM by Bill Clark.
Re: What parameters activate "bridge" extrusion
April 28, 2014 06:42AM
Slic3r will use bridge speed and flow every time it is extruding in free air or over sparse infill.
Sorry, only registered users may post in this forum.

Click here to login