Dendritic of Binary-Tree Growth Support Material
Posted by shafri
|
Dendritic of Binary-Tree Growth Support Material July 07, 2014 08:24AM |
attached picture is my custom made support structure for overhang. benefit:
1) minimal material usage
2) faster to print
3) easier to remove
4) highly suitable for cheaper single extruder printer.
i think if its can be done algorithmitically in software such as slic3r it would be nice, wouldnt it?
overhang bridges and structures...
internal overhead floor...
Edited 2 time(s). Last edit at 07/07/2014 12:22PM by shafri.
1) minimal material usage
2) faster to print
3) easier to remove
4) highly suitable for cheaper single extruder printer.
i think if its can be done algorithmitically in software such as slic3r it would be nice, wouldnt it?
overhang bridges and structures...
internal overhead floor...
Edited 2 time(s). Last edit at 07/07/2014 12:22PM by shafri.
Sorry, only registered users may post in this forum.