I am trying to use proper support settings in Slic3r to have these models print properly. They are a bird chess set on Thingiverse. The models with the lower tails seem to have issues printing and appear to need to be supported. I printed the PAWN bird and it did amazing at .2 mm slices with 2 perimeters.
Attempted printing of the King Model and the tail started to fall away and became blobs sorta.
Any suggestions would be welcomed.
The models in question can be viewed here
Bird Chess Set -Thingiverse
Edited 2 time(s). Last edit at 09/27/2014 09:58PM by BD0G.