Min layer time May 04, 2015 09:56PM |
Registered: 11 years ago Posts: 22 |
Re: Min layer time May 05, 2015 09:16AM |
Registered: 10 years ago Posts: 2,472 |
Re: Min layer time May 05, 2015 01:31PM |
Registered: 11 years ago Posts: 22 |
Re: Min layer time May 06, 2015 07:36AM |
Registered: 10 years ago Posts: 2,472 |
Quote
braddo99
Yes, I do frequently use the sacrificial tower approach and the print two approach, as I alluded in the OP.
I'm wondering about the Slic3r feature which is already there to address short time layers this seems to be doing something non-intuitive.
I suppose just slowing down would help if your top feature were, say a thin raised lip around the perimeter of an object.
But I think the more common error is the "pointy thing at the top" type of problem, for which it seems there could be an in-build solution.
Re: Min layer time May 06, 2015 07:44AM |
Registered: 9 years ago Posts: 893 |
Re: Min layer time May 06, 2015 10:10AM |
Registered: 11 years ago Posts: 22 |
Re: Min layer time May 06, 2015 05:02PM |
Registered: 11 years ago Posts: 1,320 |
Quote
braddo99
Seems Matterslice has this option but it doesn't appear to do a retraction so filament oozes all over while the extruder is hanging out.
Re: Min layer time May 09, 2015 08:11AM |
Registered: 11 years ago Posts: 22 |