Welcome! Log In Create A New Profile

Output Slic3r

calogerom

Output Slic3r
May 16, 2015 09:56AM

Registered: 9 years ago
Posts: 83

Hello everyone!
I would make a G-Code interpreter. To make this I want to use Slic3r. But I have a question: what is the complete list of G code that Slic3r can provide output? Depends on firmware that you select?

Reply Quote

IMBoring25

Re: Output Slic3r
May 16, 2015 10:35PM

Registered: 9 years ago
Posts: 351

I haven't used it but there's a checkbox for verbose output that will comment about what's going on. Does that not do what you're trying to do?

Reply Quote

george4657

Re: Output Slic3r
May 17, 2015 01:21PM

Registered: 9 years ago
Posts: 119

Go to this site. It will show you all the codes different controllers use
[reprap.org]