Welcome! Log In Create A New Profile

Linux segfault on start

Posted by epicepee

epicepee

Linux segfault on start
June 03, 2015 04:22PM

Registered: 11 years ago
Posts: 471

I'm on Arch x64, building from source. Slic3r crashes before it can start, giving a segmentation fault. I've tried this both with code straight from Git, and with the 'slic3r' AUR package. 'slic3r-bin' works fine, but it's old.

This does not happen with --no-plater (or no gui), so it seems to be an issue with the plater.

Anyone else have this happen? Should I post the core dump?

Edited 1 time(s). Last edit at 06/03/2015 04:23PM by epicepee.

Reply Quote

tadawson

Re: Linux segfault on start
June 03, 2015 06:38PM

Registered: 9 years ago
Posts: 606

Quote
epicepee
I'm on Arch x64, building from source. Slic3r crashes before it can start, giving a segmentation fault. I've tried this both with code straight from Git, and with the 'slic3r' AUR package. 'slic3r-bin' works fine, but it's old.

This does not happen with --no-plater (or no gui), so it seems to be an issue with the plater.

Anyone else have this happen? Should I post the core dump?

Try a build from source? I'm not on that distro, but am on Linux x64 (Slackware), and have never had a source build fail to run. Easy too: just run 'perl Build.PL --sudo' and 'perl Build.PL --sudo --gui' from the source dir.

- Tim

Edited 1 time(s). Last edit at 06/03/2015 06:38PM by tadawson.

Reply Quote

epicepee

Re: Linux segfault on start
June 04, 2015 01:03AM

Registered: 11 years ago
Posts: 471

Yes, I tried that. It has the same issue.

I found this on the Slic3r Git page, but I can't find the libraries they talk about.