Welcome! Log In Create A New Profile

Advanced

Where to enter the filament cost parameter

Posted by Replace 
Forum List Message List New Topic
Replace
Where to enter the filament cost parameter
August 22, 2018 03:28PM
In Slic3r, when sliced, the number of mm. filament is predicted on the output pane.
Below is an empty cost field.

I can not find a parameter to enter my filament cost, to make use of this output field.
Any advice ?

Thomas

www.3daybreaker.blogspot.com

Orca V4.4 rebuild to Ramps with Mk8 and E3D, as well as a Rostock Delta Mini and an OLO in backorder :-)
Reply Quote
o_lampe
Re: Where to enter the filament cost parameter
August 23, 2018 01:57AM
In the prusa edition it's there:

Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login