bridging problem
December 16, 2018 08:13AM
slic3r ver 1.3.1 dev - dated 12-02-18
repetier 2.1.3
Marlin 2.0
Print file created in Sketchup 2017 make - STL file attached in ZIP
Mavic_2_legs_extensionfront.zip

At layer 200 it is suppose to create a bridge layer, then 2 more, then infill.
The print preview in Repetier shows it properly. However, when it prints the bridge is only connecting to one side.
It then bridges again properly @ layer 261 and continues with 100% infill (Slic3r's choice).
Otherwise, the whole print is OK.

What is the problem?

Edited 2 time(s). Last edit at 12/16/2018 09:02AM by ruggb.
Sorry, only registered users may post in this forum.

Click here to login